4/16/2021 0 Comments Install Maxtor External Hard Drive
I would try deleting the existing partition in windows and repartioning and formatting either with win 2000 utilities or with third party partitioning utilities.Having trouble installing a piece of hardware Want to know if that peripheral is compatible with Linux.Welcome to LinuxQuestions.org, a friendly and active Linux Community.
By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features. Join our community today Note that registered members see fewer ads, and ContentLink is completely disabled once you log in. Are you new to LinuxQuestions.org Visit the following links: Site Howto. Having a problem logging in Please visit this page to clear all LQ-related cookies. For more advanced trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration. This book contains many real life examples derived from the authors experience as a Linux system and network administrator, trainer and consultant. I have contacted both Maxtor and Redhat, and neither offer support for this, but indicate that you may be able to get it to work. One catch: we have purchased support from redhat, but their support will be invalidated if we change the kernel in any way. The kernel was no problem and I believe Rh 9 should have the necessary usb, usbstorage and scsi modules available out of the box. You might want to check with rh support to see if usb 2.0 is supported. If not, you might be able to get it running but it will be dog slow with usb 1.1. On to the big problem. My drive came from the factory with one 120GB FAT32 partition. Maxtor External Hard Drive Software The DriveNo problem in windows here; after installing the windows software the drive was detected and I could read and write to the drive in windows 98SE. To my suprise, the drive was automatically detected using device file devsda however the partition on the drive was not detected at all; the entire drive was designated unallocated. I then tried to repartition and reformat using linux partitioning tools. Big mistake When I tried to format the partition I created I got error messages re overlapping partitions and the format wouldnt go. I booted back to windows and used Acronis Partition Expert to delete all partitions on the drive and then created two extendedlogical drives, one 100GB and the remaining space 20GB, and formatted both FAT32. Crossed my fingers, booted back to linux and thankfully both partitions were detected as sda5 and sda6. I was able to mount and readwrite to the partitions and hdparm showed transfer rates of 23MBsec so usb 2.0 was definitely working. For convenience I set up a fstab entry for sda5 as follows: devsda5 mntrem vfat user,exec,noauto,codepage850,iocharsetiso8859-1,quiet,umask0 0 0 I did the same on my debian install and was also able to get it working but only at usb1.1 speeds. Knoppix also recognizes the drive as sda5 when booting off the knoppix cd but again will only work at usb1.1 speeds. Based upon my experience, the factory partition and format is not compatible with linux.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |